16
outlet. Slide the adapter through the mounting box before screwing
the box onto the wall.
2. Follow the steps outlined above for either surface or flush mounting of
the alarm.
3. Adapter wire is run underneath the mounting bracket when installing a
flush mounted alarm.
OPERATING INSTRUCTIONS
Applying power to the detector will cause the LED to flash red for 3 minutes
and then turn green. Once LED is green, detector is monitoring for LP gas.
DETECTOR TEST
1.
Press “TEST” button until alarm sounds; then release the “TEST”
button.
2. The detector will sound twice.
3. The LED will turn red, and then return to normal operation and turn
green after 8 seconds.
4. This test must be carried out not less than once per week to ensure
proper operation of the detector.
Lp Gas Detection
At <25% LEL concentration of LP gas the detector will provide a visual and
audible alarm by sounding the buzzer and turning the LED Red. The
buzzer may be temporarily silenced by pressing the Test/Reset button.
However, until the measured concentration is reduced to a safe level, the
alarm will sound again within 3 minutes.
POWER MANAGEMENT
The operating voltage for the detector is 12 VDC. In these conditions, the
unit will meet the specifications of the UL 1484 standard. The actual
