6
vehicle.
Do not start vehicle’s engine or electric generator.
Contact nearest gas supplier or qualified Service Technician for
repairs.
If you cannot reach a gas supplier or qualified Service Technician,
contact the nearest fire department.
Do not run on gas supply until gas leak(s) have been repaired.
TESTING
Note: Unit must be powered for three minutes before test can be
performed.
The Test/Rest button is used to verify proper alarm operation. Executing
the test function sounds the alarm and lights up the LED. The test will
sound the alarm twice, with 4 “beeps” in 1 second followed by 5 seconds of
silence.
By pressing the button, you can verify that the alarm sounds and that the
LED functions properly. The alarm is internally monitored while powered to
ensure proper operation and to detect faults.
Important
This detector will only indicate the presence of LP gas at the sensor.
Gases may be present in other areas.
The detector is not suitable as a smoke or fire detector. Not suitable
for installation in hazardous locations as defined in the National
Electrical Code.
