MAN - PAV4 - REV: Original | E. Software Overview
12
The screen will show values for current chamber temperature and pressure, chamber set point, remaining cycle time,
and error times. It also has several controls to set-up and run the pressure aging vessel (PAV).
Preheat Button
Used to heat the PAV up to operating temperature before loading samples into the vessel.
Age Cycle Button
Used to tell the system that parts are loaded, to start the recovery for the age cycle.
End/Stop Button
Used to tell the system to finish the cycle. It can also be used anytime the PAV is in cycle to stop the age cycle. When
the age cycle has finished this button will blink to show the cycle is finished. If pressed while in an aging cycle a pop-
up dialog will ask if you are sure you wish to end the current test.
Shut Off Button
Can be used at any time to shut down the PAV. This will stop all cycles, shut off heat, and reset the system to the off
state. If pressed a pop-up dialog will ask if you are sure you wish to end the current test.
Figure E.2: PAV Main Screen
