Atrie DB-120 User Manual
User Manual
26
logging, you must specify a severity level for each facility; messages that belong to the facility and are
rated at that level or higher are logged to the destination
Table 1 defines the different severity levels.
To forward logging information, you need to click on Tools (at the top of the page) and select Remote
Log.
Table 1 (Severity Level)
3.7.3
USER MANAGEMENT
You can change your gateway’s username and password by going to the Home screen, under the tools
menu, click User Management. From here you can change the login name and password. You can
also change the idle timeout; you will need to log back onto the gateway once the timeout expires.
If you forget your password, you can press and hold the reset to factory defaults button for 10 seconds
(or more). The gateway will reset to its factory default configuration and all custom configurations
will be lost.
The apply button will temporarily save this connection. To make the change permanent you need to
click on
Tools
(at the top of the page) and select
System Commands
. At the system commands page,
click on
Save All
.
3.7.4
UPDATE GATEWAY
You can remotely upgrade the gateway’s firmware by going to the Home screen, under the tools title,
click Update Gateway. This will bring up the screen shown in Figure 19. We will provide two
different images; one image is the kernel (operating system) and the other image is the file system.
To upgrade the firmware, click browse, find the firmware file to download. Make sure this is the
correct file. Click on upgrade firmware (as shown in Figure 19). Once the upgrade is complete the
gateway will reboot. You will need to log back onto the gateway after the firmware upgrade is
complete.
The firmware upgrade should take less that 5 minutes to complete. If it takes longer than 5 minutes,
something has gone wrong.
Note: Do not remove power from the gateway during the firmware upgrade procedure.
