Atrie DB-120 User Manual
User Manual
10
Since multiple users can use the gateway, the gateway can simultaneously support multiple connection
types; hence, the user must set up different profiles for each connection. The gateway supports the
following protocols:
•
DHCP
•
RFC 2364 PPPoA
•
RFC2516 PPPoE
•
Static
•
Bridged
•
CLIP
.
3.4.1
NEW CONNECTION
A new connection is basically a virtual connection. Your gateway can support up to 8 different
(unique) virtual connections. If you have multiple different virtual connections, you man need to
utilize the static and dynamic routing capabilities of the modem to pass data correctly.
3.4.1.1
BRIDGE GATEWAY PROFILE AND CONNECTION
A pure bridged connection does not assign and IP address to the WAN interface. NAT and firewall
rules are not enabled. This connection method makes the router act as a hub, and just passes packets
across the WAN interface to the LAN interface.
To configure the gateway as a bridge, from the Home page, click on Setup and then click on
New
Connection
. The default PPPoE connection setup is displayed. At the Type field select
Bridge
and
the Bridge connection setup page is displayed (see Figure 4). Give your Bridge connection a unique
name; the name must not have spaces and cannot begin with numbers. In this case the unique name is
called
bridge1
. Select the encapsulation type (LLC or VC); if you are not sure just use the default
mode. Select the VPI and VCI settings; your DSL service provider or your ISP will supply these; in
this case the DSL service provider is using
0,35
. Also select the quality of service (QOS); leave the
default value if you are unsure or the ISP did not provide this information.
Figure 4 (Bridge Connection Setup)
