28
Atmel AVR2052
8200M-AVR-11/11
9 Appendix A-3: ATmega128RFA1 specifics
9.1 Getting started
The Atmel BitCloud SDK supports two different development platforms with Atmel
ATmega128RFA1: ATRF4CE-EK
Atmel ATSTK600 boards
. The instructions below highlight the differences
between the two platform configurations, where present.
9.1.1 Required hardware
Before installing and using the BitCloud SDK for ATmega128RFA1, make sure that all
necessary hardware is available:
•
For ATRF4CE-EK:
o
Two or more RCB128RFA1 boards with 2.4GHz antennas and AAA
batteries
o
one or more RCB breakout boards (other boards from the kit may be
used, too)
o
one RS-232 interface cable for the RCB breakout board
o
Atmel AVR JTAGICE mkII or Atmel JTAGICE 3
•
For ATAVR128RFA1-EK1:
o
Two or more ATSTK600 boards, each with an Atmega128RFA1 top
card and 2.4GHz antenna
o
AVR JTAGICE mkII or Atmel JTAGICE 3
9.1.2 Hardware setup
For the RCB128RFA1, please refer to
for hardware setup instructions.
Figure 9-1.
Jumper setting for STK600-ATmega128RFA1 top card.
ATAVR128RFA1-EK1 requires the following setup:
