AT-UHD-PRO3-1616M
56
Source devices (at the headend) can be controlled from the viewing location. IR control depends upon the current
routing state: only the currently viewed source can be controlled using IR.
Controlling Headend Devices
1.
Connect the IR receiver (AT-IR-CS-RX) to the HDBaseT receiver, at the viewing location. Although a control
system can be used, a basic IR receiver is commonly used.
2. Connect an IR emitter to the desired
IR OUT
port on the AT-UHD-PRO3-1616M. Make sure the source device is
within range of the IR emitter.
In the example below, the
HDMI IN 4
has been routed to
ZONE OUT 6
. The IR remote control for the Set Top
Box (STB) is connected to the HDBaseT receiver (AT-UHD-EX-100CE-RX) on
ZONE OUT 6
. As long as the STB
is routed to
ZONE OUT 6
, the STB can be controlled from the viewing location. If a different source is routed to
ZONE OUT 6
, then the STB can no longer be controlled from the viewing location, using IR.
HDBaseT
(ZONE OUT 6)
HDMI
HDMI
(HDMI IN 4)
IR Emitt
er
(IR OUT 4)
AT-UHD-PRO3-1616M
IR Remote
(Set-Top Box Control)
AT-MRC-IR
(Matrix Control)
AT-UHD-EX-100CE-RX
Set-Top Box
Display
IR R
eceiv
er
SET
-TOP BO
X
OK
224
AT-UHD-PRO3-1616M
FCN
CANCEL
EDID
INFO
POWER
ENTER
IR Signal
AT-MRC
Power
On
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Off
Input
Volume
Output
Advanced Operation
NOTE:
In addition to IR control for the headend device, the AT-MRC-IR can also be used from the
viewing location to control the AT-UHD-PRO3-1616M.
