Atlas Copco ZR 110, Инструкция

Страница: 67 / 328

• Using scroll keys (1), modify this command as required, as described below in section “Modifying a
command”. Add and delete commands as required, as described below in sections “Adding a
command” and “Deleting a command”.
• Activate the timer as described below.
Activating/deactivating the timer
• The timer can only be activated if at least one start/stop command is programmed.
• Select the menu “Timers”. Press the key “Modify”, the message “The Timer is not activated” will
blink.
• Use scroll keys (1) to change the message into “The Timer is activated”.
• Press the key “Program” to program the Timer active function or key “Cancel” to cancel the
modifying operation. If activated, the regulator will execute the programmed commands.
The timer can be deactivated again. In this case, the programmed start/stop commands will
not be executed (but remain in the memory of the regulator).
Displaying the list of commands
• Press the key “List” on the timer screen. A typical display is shown below:
Monday 06:00 Start compressor
Monday 17:00 Stop compressor
Tuesday 07:00 Start compressor
Menu Modify List
F1 F2 F3
• The vertical arrows at the right-hand side indicate to use the vertical scroll keys to select the next and
previous start/stop commands. The horizontal arrow indicates the command which is accessible at
that moment.
• Use the key “Menu“ to return to the submenu or the key “Modify” to modify the start/stop
commands.
• After pressing the key “Modify”, three selections are shown on the bottom line of the display:
Monday 06:00 Start compressor
Monday 17:00 Stop compressor
Tuesday 07:00 Start compressor
Modify Add Delete
F1 F2 F3
Use key:
• “Modify” to modify the command indicated by the horizontal arrow.
• “Add” to add a new command at the location of the horizontal arrow.
• “Delete” to delete start/stop commands.
Instruction book
2920 1815 04 65