Manual, Control Module, PROFINET, DL10
Document #9620-20-C-DL10-04
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 • Tel: 919.772.0115 • Fax: 919.772.8259 •
C-26
3.5 Setting the Tool-ID
(5) push‑button switches are provided on the Tool module for setting of a Tool‑ID number. Each Tool must
have a unique 5 digit Tool‑ID number.
Tools required: Phillips screwdriver
Figure 3.3—Setting the Tool ID
Decrease (-) Digit
Increase (+) Digit
Set Tool ID to an
Unique 1-Digit Number
for each Tool
Window
(4) M3 Captive
Head Screw
O-ring Seal
SW5 SW1
←
1. Loosen the (4) M3 captive head screws and remove the Tool‑ID window.
2. Use a non‑conductive tool (e.g., plastic stylus) to press on the Tool‑ID push‑buttons to increase (+) or
decrease (‑) the digit value from 0 to 9. Set the Tool‑ID to the desired unique (5) digit number from
00000 to 99999 for each tool.
3. Re‑install the Tool‑ID window and tighten the M3 captive head screws.
3.6 PROFINET Interface
The PROFINET interface parameters and I/O bitmaps in the modules are found in
PROFINET Interface Information
of the manual. These should be thoroughly understood prior to operating
the Tool Changer. A detailed operational sequence is provided in
Section 4.4—Recommended Sequence of
3.7 Utility Schematic
Refer to drawings in
for customer interface and wiring details for the modules.
3.8 Electrical Connections
Refer to drawings in
for the electrical connections and pin/signal information.
