Athena GET ECULMB RACE KIT, Руководство по установке

Страница: 13 / 112

13 EN
ATTENTION: Before starting the idle regulation
procedure, make sure the emergency OFF switch is
in run position and the throttle is completely closed.
Make the setting in small steps.
1.
Find the idle screw on the throttle valve body on the left
side of the bike, between the airbox and the intake manifold.
Otherwise, check on your motorbike’s workshop manual
where to find it.
2.
Turn the idle screw clockwise to decrease the idle
speed and to start the tuning.
Turn it counterclockwise to increase the idle speed:
• For MY 2018/2019 bikes, rotate the screw
counterclockwise for 2,5 turns.
• For MY 2020/2023 bikes, rotate the screw
counterclockwise for 4,5 turns.
3.
If you encounter any engine irregularities after a
correct idle regulation, GET suggests performing the
ZERO TPS Calibration (see following section).
ZERO TPS CALIBRATION
Zero TPS Calibration allows GET ECULMB to properly recognize
when the throttle is completely closed, and to ensure accurate
readings of the fuel level injected into the combustion
chamber. When installing a new ECU or other accessories,
GET recommends carrying out the Zero TPS Calibration. This
calibration will ensure a correct fuel calculation, so the motorbike
can accelerate accurately, and it will avoid poor fuel economy.