ATEN VM6404H, Руководство пользователя

Страница: 43 / 107

Chapter 3. Front Panel Configuration
31
IR Remote Control Operation
The IR remote control (
IR Remote Control
, page 7) included with the
VM6404H can be used to:
Š change the Input source of any Output display
Š power on/off individual Output displays; or
Š power on/off all Output displays simultaneously
Before using the remote control, a user must first plug the IR External Receiver
into the rear panel of the VM6404H and place the receiver where the IR signal
can be reached (see
IR Port
, page 6).
Change the Input source of an Output display
To change the Input source of an Output display, using the remote control, do
the following:
1. Press the
Output
port number (
1-4
) you want to change.
2. Within 2 seconds press the
Input
port number (
1-4
) you want the Output
port to display.*
3. Repeat steps 1-2 to change additional ports.
*For the change to occur the Input number must be pressed within 2
seconds of pressing the Output number.
Power on/off individual Output displays
To power on/off individual Output displays, using the remote control, do the
following:
1. Press the
Output
port number (
1-4
) you want to power on/off.
2. Within 2 seconds press the
ON
or
OFF
pushbutton.*
3. Repeat steps 1-2 to change the power status back on/off.
*If the
ON
or
OFF
pushbutton is pressed
after
2 seconds of pressing the
Output port number, all the displays are powered on or off instead of just
the intended Output port.