[50]
When the work pieces are moved up to make zero all axes you will find the work piece centre.
5.16.3.
Measurement
To measure with contact probe when the probe is contacted to the work piece on the opened menu find
“MEASURE“
section by
buttons and press enter to select. Probe must be contacted to Point 1.
On the opened function menu, the measure effect of probe is adjusted. If the measure of the work piece will be
taken as in the Picture 1 press “1” button and see “+DIAMETER” writing on the screen. If the measure of the work
piece will be taken as Picture 2 press “0” button and see “-DIAMETER” writing on the screen. Press “Sx” button and
enter probe diameter and press enter to save. Press
button to see “POINT 1“ writing . Press button of the axis
selection. When you uncontact the probe device save Point 1. When you contact Point 2 the length will be deal to
user.
Example:
5 mm
Lenght?
As the left side picture to find inner dimesions of Y
axis
(First contact Position;
X: 26.110
Y: 61.200
Z: 0.000 )
Şekil 1
Şekil 2
Point 1
Point 1
Point2
Point2
Probe diameter
Nokta 1
Find
“MEASURE”