[11]
3.6.5.
Probe Logic Level Setup
It can be needed to change according to used probe.
If there is a signal after probe contact (High-Active) must change as “1”, if there is no any signal (Low-Active) must
be change as “0”. Press “ENTER” to save.
3.6.6.
Buzzer Close
Buzzer voice can be closed by this menu.
It can be closed by “1” button and can be opened by “0” button.
3.6.7.
Return to Factory Settings
It is used to reset all functions changes.
In the menu to return factory settings please press to “Enter” button. “SURE” writing is seen. Press again to
“ENTER”. “WAIT” writing is seen and after a while it turns to fabric setup.
3.7.
Test
In system setup menu the device can be tested. You can make display, eeprom test, CPU test, and Relay Test.
Press “Enter” button to enter the menu.
3.7.1.
Display Test
It exist in test menu. It can be active by “ENTER” button.
After pressing “Enter” button it clicks all the LED and display segments. Only “Probe” LED can’t be test. To stop the
testing press
button.