Asus RX3041H, Руководство пользователя

Страница: 111 / 143

RX3041H User’s Manual Chapter 11. System Management
97
Note
Changing the date and time on the router does not affect the date
and time on your PCs.
There is no real time clock inside the router; however, the correct date and time can be obtained from external
time servers. You may configure up to 5 time servers. Note that SNTP service must be enabled in the
System
Services configuration page for the router to access external time servers.
11.4.1 Date/Time Configuration Parameters
The following table describes the available configuration parameters for date and time setup.
Table 11.2. Date/Time Configuration Parameters
Field Description
Date The date is reset to 1/1/2000 whenever the router reboots and no SNTP
servers are accessible. Correct date will display in this field if SNTP service is
enabled and the configured SNTP servers are accessible.
Time The time is reset to 00:00:00 after the router reboots and no SNTP servers
are accessible. Correct time will display in this field if SNTP service is enabled
and the configured SNTP servers are accessible.
Time Zone Enter the time zone for your region.
SNTP Server 1 – 5 Enter the IP address of the SNTP servers. Up to 5 SNTP servers can be
configured for the router to obtain correct date and time.
Update Interval Enter the update interval in minutes for the router to get the update date and
time from the time servers. The default setting is 60 minutes.
11.4.2 Maintain Date and Time
Date and time can be maintained by the router itself by entering correct date and time in the Date and Time
fields respectively. Note that you must manually set the date and time again each time the RX3041H reboots.
It is recommended that you use external time servers to help maintain the date and time for your router. Follow
the instructions below to configure SNTP servers to maintain date and time for your router:
1. Open the Date/Time configuration page by clicking the System
Management
Î
Date/Time menu.
2. Select a time zone setting from the " Time Zone " drop down list for your
region.
3. Enter up to 5 SNTP server IP addresses accessible for your region.
4. Enter the time update interval in the " Update Interval " field. The default
update interval is 60 minutes.