AstroNova QuickLabel QL-850, Руководство пользователя

Страница: 103 / 127

Rewinder
QL-850 User Guide 103
Installing the Rewinder
Use the following instructions to install the rewinder. Refer to the following illustration during this
process.
Note: These instructions assume you are using the rewinder accessory only. If you are also
using the unwinder accessory, the installation procedure will differ.
See “Installing the Rewinder
when using the External Unwinder” on page 104.
1. Ensure the power switch [6] on the rewinder is in the off position.
2. Power off the printer. On the rear of the printer, turn the power inlet switch off.
3. Disconnect the accessory cover [1] by removing the two upper [2] and two lower [3]
screws.
Note: The upper and lower screws are different sizes. Keep these screws separated to
ensure correct installation later in the procedure.
4. Orient the rewinder bracket [4] as illustrated. Insert the tabs from the bracket into the
printer and align them with the lower accessory cover mounting bosses.
5. Reinstall the accessory cover [1] using the two upper [2] and two lower [3] screws. The
lower screws will capture and secure the tabs from the rewinder bracket [4].
6. Remove the two thumb screws from the rewinder [5].
7. Align the rewinder [5] with the rewinder bracket [4]. Ensure the thumb screw mounting
locations align with the slotted holes on the bracket.
[1]
[2]
[3]
[4]
[5]
[6]