NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
9
Install optional surround
1. Remove clean face trim and install brackets -
Remove
the clean face frame shown in
Figure 27
.
Attach surround
mounting brackets to unit (10 screws)
.
See
Figure 25
.
Surround will be mounted to these brackets
(see
Figure 26
).
2.
Attach the surround and secure it using the nine (9) screws
provided with the surround kit
(
Figure 26
).
Finishing with optional Surround and Bezel
1. With unit in framing, secure nailing fl anges to the wall framing.
2. Retrieve and secure heat shield to top front of unit with two
screws.
3. Remove the clean face frame (see
Figure 27
)
.
4. Place insulation fl at across the top of the fi replace lengthwise
behind heat shield.
5. Install top, bottom and two (2) side surround support pieces
with screws from step 1 (see
Figure 27
)
.
6. Cut top noncombustible fi reboard to size and install fl ush with
top frame pieces (side noncombustible boards not used).
7. Install glass media.
8. Remove top, bottom and two side trim pieces of barrier as-
sembly. Insert remaining barrier assembly into bezel assem-
bly and attach with screws.
9. Reinstall the door.
10. Attach surround to surround support with six (6) screws.
11. Hang barrier assembly on door and snap underneath door.
Surround mounting
brackets (provided
with surround kit)
Clean
Face Frame
(removed first)
Bezel and Barrier
(added after Surround
- not shown)
One (1) Top non
-combustible
board
Clean
Face Frame
(removed first)
Figure 25 - Surround Mounting Brackets
Figure 26 - Installing optional surround
Figure 27 - Remove clean face trim and install brackets
f i r e - p a r t s . c o m