NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
3
To remove optional Bezel:
Grasp lower portion of bezel frame and pull forward to release
from bottom of door.
Swing bezel out slightly and lift up to clear top bracket from
door frame.
If Bezel is installed, barrier frame shown in
Figure 2
will not be
present.
Remove glass door assembly
1.
Remove the three (3) screws securing the lower edge of the
glass door assembly to the fi replace
(
Figure 3
)
.
2.
Grasp the glass door assembly by the sides, swing the lower
edge out, and then lift up to unhook it from the fi replace.
NOTE:
Take care not to damage the glass.
3.
Set aside the screws and glass door assembly in a secure
location for later reinstallation.
Glass Door Assembly
[CROSS-SECTION]
Barrier
Flanges
Door Trim
Barrier
Figure 2 - Removing the bezel
INSTALLATION INSTRUCTIONS
Complete all steps in the order shown, including the installation
of optional accessories (if applicable).
Remove barrier assembly
1.
Remove the barrier assembly by lifting it up to disengage its
notches from tabs and pull directly away from the fi replace.
2.
To replace the barrier if damaged, remove the three (3)
screws from the top and bottom and one (1) screw from
each side. Reverse these instructions to install the new
manufacturer's barrier
(
Figure 2
)
.
Figure 3 - Removing the glass door assembly
Remove baffl e from fi replace fl oor, if installed
1.
If unpacking the fi replace for the fi rst time, remove the
baffl e from fi replace fl oor, where it is packed for shipping
(
Figure 4
)
.
2.
Set aside the baffl e in a secure location for later installation.
Baffl e (as shipped)
Figure 4 - Removing the baffl e
Access the control compartment
1.
Remove the two (2) screws securing the burner assembly
to the burner brackets. Carefully slide the burner to the left,
to clear the venturi from the orifi ce. Rotate the burner to
release the air shutter adjustment rod from the air shutter
lever
(
Figure 5
)
. Lift and remove the burner assembly,
and set aside the screws and burner assembly in a secure
location for later reinstallation.
Air Shutter Rod
Figure 5 - Releasing the air shutter adjustment rod
Figure 6 -
Accessing the control compartment
2.
Remove the control compartment access door and gasket by
removing the twelve (12) screws securing it. Set aside the
screws, door, and gasket for later reinstallation
(
Figure 6
)
.
f i r e - p a r t s . c o m