NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
8
Gather and reseal all wiring
1.
Gather all wiring and pilot connections together at the end
of the slot, and reseal with high-temperature sealant, such
as Mill-Pac
®
(not provided)
(
Figure 7
)
.
2.
Reposition the right burner bracket and secure with the
three (3) previously removed screws; tighten the fourth
screw
(
Figure 7
)
.
3.
Replace the control compartment access door and gasket,
and secure with the twelve (12) previously removed screws
(
Figure 7
)
.
4.
Carefully slide the burner assembly venturi onto the orifi ce.
While placing the burner assembly onto the brackets,
reinstall the air shutter adjustment lever
(
Figure 5
)
. Secure
the burner assembly with the two (2) previously removed
screws.
Install rear fl oor section (from required fl oor kit)
1.
Place lower back edge of rear fl oor section on rear ledge of
fi replace, behind the tabs
(
Figure 22
)
.
2.
Align outermost front hole on either side of rear fl oor
section with hole in center lower tab in each side panel. Pull
rear fl oor section forward until it butts against the burner,
and secure using fi ve (5) #10-16 x 3/8 hex-head sheet
metal screws provided with the fl oor kit.
Rear
Floor
Section
Rear
Ledge
Tab
~
Side Panel
(Center Lower Tab)
Figure 22 - Installing the rear fl oor section
Install front fl oor section (from required fl oor kit)
1.
Engage the lower front lip of the front fl oor section under
the locking clips attached to the fi replace front ledge, and
then slide it back
(
Figure 23
)
.
2.
Align the notches in the back edge of the front fl oor section over
the holes in the rear fl oor section. Push the front fl oor section
backward until it butts against the burner, and screw the front
fl oor section as shown in
Figure 23
.
Locking Clip
Front
Ledge
Notch
Rear
Floor
Section
Front
Floor
Section
Lip
Figure 23 - Installing the front fl oor section
Install media (from optional media kit)
WARNING
• Handle media only when cool. Turn OFF all electricity
to the appliance before installing media. Media gets
very HOT during fi replace use and will remain hot up
to ONE HOUR after the gas supply is turned off.
• Any attempt to use media not specifi ed for your fi replace
confi guration will result in incomplete combustion,
sooting, and poor fl ame quality, and will void the
warranty.
• Do NOT mound up media, especially on the burner.
• If using multiple colors of media, NEVER use more
than fi ve (5) pounds total (approximately) at one time.
• Do NOT allow media to get into the pilot hole.
1.
If installing a fl oor kit that requires media, place an even
layer of media in the recessed area around the burner (see
bold outlined area in
Figure 24
; also refer to
Figure 1
)
.
Figure 24 - Placement of media
f i r e - p a r t s . c o m