INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
12
Printed in U.S.A. © 2014 Innovative Hearth Products
P/N 900077-05 Rev. A 09/2016
1508 Elm Hill Pike, Suite 108, Nashville, TN 37210
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifi cations, prices and also to discontinue colors, styles, and products. Consult your local
distributor for fi replace code information.
APPENDIX: ALTERNATE INSTALLATION INSTRUCTIONS
Route and connect optional fi rebox panel backlight kit
wiring and install lamp assemblies
NOTE:
These instructions should be used in place of
Route and
connect optional fi rebox panel backlight kit wiring and install
lamp assemblies
on
Page 6
, for fi replaces without backlight
wiring kit routing holes as shown in
Figure 14
on
Page 6
.
1.
Route one set of three leads (white/green/black) through
the hole in the front of the bracket
(
Figure 33
).
Front of Mounting Bracket
Figure 33 - Routing wires through lamp bracket
2.
Connect the green wire to the lamp (
Figure 34
)
.
3.
Insert the lamp (with green wire attached) into bracket until
the spring clip is engaged (
Figure 34
)
.
4.
Connect the white (neutral) wire, and black (hot) wire
(
Figure 35
)
.
Figure 34 - Attaching green wire to fi rebox panel backlight
kit lamp, and inserting lamp into lamp bracket
Figure 35 - Attaching black and white wires to fi rebox
panel backlight kit lamp
5.
Repeat the process in
step 1
through
step 4
for the two
remaining lamp assemblies.
6.
Carefully lay the fi rebox backlight lamp assemblies and
wiring on the fi replace fl oor. The lamp assemblies will not
be installed until the back panel is installed (in a later step).
7.
Remove the three (3) cover plates in the lower front face
of the back panel. Discard the cover plates, but retain the
screws.
8.
Insert the three (3) previously assembled lamp assemblies
in the orientation shown
(
Figure 36
)
.
NOTE:
The wires will be routed under the rear fl oor section
in the next step.
9.
Secure the lamp assemblies using the six (6) previously
removed screws from the cover plates.
Cover Plate
Note orientation of each
lamp assembly.
Figure 36 - Installing the lamp assemblies
NOTE:
When installing the rear fl oor, route the fi rebox
backlight wiring through the notches under the rear fl oor
section. Be careful not to pinch or damage the wires.
f i r e - p a r t s . c o m