Astria Fireplaces Rhapsody42 Series, Руководство по установке, Страница: 6 / 12

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
6
Backlight Wire
Routing Holes
Figure 14 - Routing wiring
2 . If the fi rebox r
ear ledge has backlight wire routing
holes, proceed with the instructions in Route and
connect optional fi rebox panel backlight kit wiring
and install lamp assemblies below.
If the rear ledge does not have backlight wire
mounting holes, follow the instructions detailed in
Route and connect optional fi rebox panel backlight
kit wiring and install lamp assemblies as shown on
this page.
Route and connect optional fi rebox panel backlight kit
wiring and install lamp assemblies
1. Remove the three (3) cover plates in the lower front face
of the back panel. Discard the cover plates, but retain the
screws.
Figure 15 - Removing the cover plates, and routing the wiring
2. Route one set of three leads (white/green/black) through each
backlight wire routing hole in the rear ledge
( Figure 14 ) .
3. Route one set of three leads (white/green/black) through each
hole in the lower front face of the back panel
( Figure 15 ) .
4 . With one set
of three leads, connect the green wire to a
lamp ( Figure 16 ) .
5 . Insert the lamp
(with green wire attached) into a bracket
until the spring clip is engaged ( Figure 16 ) .
6 . Connect th
e white (neutral) wire and black (hot) wire
( Figure 17 ) .
Figure 16 - Attaching green wire to fi rebox panel backlight
kit lamp, and inserting lamp into bracket
Figure 17 - Attaching black and white wires to fi rebox
panel backlight kit lamp
7 . Repeat
the process in step 4 through step 6 for the
two remaining lamp assemblies.
8 . Insert the
three (3) lamp assemblies in the exact
orientation shown ( Figure 18 ).
Figure 18 - Installing the lamp assemblies
9 . Secure t
he lamp assemblies using the six (6) previously
removed screws from the cover plates ( Figure 18 ) .
f i r e - p a r t s . c o m