-17-
- Press Menu: DUR appears
- Press + twice: INT appears (INT = intensity)
- Press Menu: the amperage is displayed
- Press Menu to exit: the setting amperage appears
- Press Menu: DUR appears
- Press + three times: TPS appears (TPS = tens of hours)
- Press Menu: a number of tens of hours appears
- Press Menu to exit: the setting amperage appears
- Press Menu: DUR appears
- Press + four times: TEN appears (TEN = voltage)
- Press Menu: the voltage is displayed
- Press Menu to exit: the setting amperage appears
- Press Menu: DUR appears
- Press + five times: TEP appears (TEP = temperature of the device)
- Press Menu: the temperature of the device appears
- Press Menu to exit: the setting amperage appears
If, for any of the possible displays listed above, you do not press the Menu button,
then the device will automatically reset to Amperes after one minute.
To find a specific programme :
Use the drop-down Menu:
- Press Menu : DUR appears
- Press + until the desired programme is displayed.
Polarity inversion :
See paragraph 6
Add salt :
Check the salt content. If the concentration is less than 4 g/l, add salt according to
the following formula :
Q = (4-T) x V
Q = quantity of salt to be added in kg.
4 = salt content to be respected.
T = measured salt content in the pool.
V = volume of the pool in m3.
Always stop the device before adding salt directly to the pool.
Wait for the salt to dissolve before turning the salt chlorinator on again.
