
23
Update Process
1.
Power on the ARC2 and make sure the SD-Card is inserted.
2.
Choose SETUP > SD card > Firmware Update
3.
Choose suitable file with + and – keys, then press Enter
4.
The LCD will show “POWER ON LAMPS”. While this is shown on the ARC2, press the on/off
button of all lamps you want to update. They will not power up as usual, but stay in an up-
date mode instead (see below table to find out how this mode is shown)
If a lamp powers up as usual, either the wireless connection is bad or the .FRM file does not
match the lamp you are trying to update.
5.
When all lamps are prepared, press the ENTER key on the ARC2 to start the update.
6.
The ARC2’s display will show a progress bar. Wait until the update is completed, this will take
30-60 seconds.
7.
If the updated worked, the lamps will power up again, and behave as usual. If a lamp does
not power up, the update got stuck.
Then either directly start the update again on the ARC2, not touching the lamps, or power off
the lamps and start the whole process again.
If you want to find out which firmware you lamp is running, take a lamp with LCD-display,
hold MENU until you enter the menu, choose INFO, then FIRMWARE VERSTION.
List of Lamps and Controllers
AC2
Switch unit off, than plug in the power cord while the ARC2 shows “POWER ON
LAMPS”.
The LCD and LEDs will stay dark until the update is completed.
AL5
AL6
AL7-L
ART3
AL1
Power up normally with the power button while the ARC2 shows “POWER ON
LAMPS”.
The power/charging LED will indicate that the update is in progress. Or the LCD will
show information about the update process.
AL3
AL6 V2
AL7-W
AL9
ARC2
Insert batteries into an ARC2 while another ARC2 shows “SENDING INIT”.
A flashing LCD backlight indicates that the update is in progress.
Содержание ARC2
Страница 18: ...18 10 Appendix Appendix 1 Color Index...