
14
Strobe:
Single: One DMX channel is supplied for the control of the strobe
function, all pixels will strobe identical. When using this setting,
DMX TAB should not be set to RGB S RGB S..
Multiple: For each pixel, the stroboscope can be controlled indi-
vidually.
Off: Stroboscope is turned off globally.
DMX Failure:
Sets the behavior of the light in case of an interrupted DMX signal.
Hold: Output remains unchanged, the last received DMX frame is displayed.
Emergency Light: If the DMX reception times out, the light turns white.
Blackout:
If the DMX reception times out, all light turns black.
Remote Setup:
Usually all configuration settings, like changing the DMX address, chain con-
figuration and so on is done directly on the units. This might not be feasible if
several units with the same settings have to be configured with the same set-
tings or a unit is not equipped with a LCD-display.
Remote Group
Assigns lamps or sets into any of the 4 groups.
If not programmed, all lamps are set to group 1.
Input Select
If a lamp has several input signals (for example it is
connected to a DMX cable but should be targeted
by the ARC2) the preferred input signal can be defined
XLR DMX for the signal of wired DMX
Wireless DMX for the signal of wireless DMX
Remote Control for the radio signal of the ARC2
Standalone
to keep the last input signal (for example 1 color)
until another input source is chosen.
Auto Automatically chooses an input source
AC Failure
Emergency Light If no AC signal is detected, the light turns white.
No Action
Blackout If no AC signal, all light turns black.
Manual White Calibration:
You can enable automatic white calibration or manually
adjust the red, green and blue levels that are used to
display white color.
SD Card
Backup Keys
Saves the colors and effects that have been as-
signed to the white keys.
Choose a name with the plus, minus & Enter but-
tons. Back/Tap-sync jumps to the next set of letters,
“←” deletes, “>>” stores the keys with the chosen
name.
Restore Keys
Copies the stored keys to the ARC2's memory.
Firmware update
The ARC2 can be used to update the firmware of
most Astera lamps and controllers that are
equipped with a RF receiver (Antenna).
Please refer to the Firmware update manual in
appendix 10.5. for detailed instructions.
Содержание ARC2
Страница 18: ...18 10 Appendix Appendix 1 Color Index...