
12
6.
Targeting Lamps
A special button has been assigned to targeting only a selection of lamps that are within the reach of
the remote control. Once one of the Target lamps options has been selected by choosing ENTER,
BACK or the HOME button you will only target those selected lamps until another value in Target
Lamps is chosen.
Target lamps …
..by GROUPS Each lamp can be set to belong to one of four groups (G1, G2, G3 or G4). Then each
groups can be controlled individually, or groups can be linked together. If groups are
linked, the program pattern stretches over them. New lamps or reset lamps are set to
group 1
Only sequential groups can be linked, for example G1+G2.
It is not possible to link G1+G3.
The GROUP setting can be altered and assigned to lamps in SETUP
using the REMOTE SETUP menu.
..by SET#
Lamps can be assigned to one of 255 possible set-addresses. More than one lamp can
be assigned to one set number. In practice, usually a set of lamps will be assigned one
set number. Each of these sets can be controlled individually.
It is not possible to link sets together, so that programs stretch over
them. Sets can easily be created by using SETUP->CREATE A SET.
..by TAPPING THEM
By using this setting, lamps will not receive any information, unless they are
tapped. Tapped means, that their button is pressed after they indicate that new
information is available. Usually they do this by a short white flash every 1-2 seconds.
..by TYPE
If lamps of different types are used, they can be controlled by type. For example, if
you have AL6 and AL3-S setup, they can be controlled individually by choosing their
type.
..by SERIAL NUMBER
If the serial number of a lamp is known, it can be addressed directly by
entering the S/N into the remote control.
Содержание ARC2
Страница 18: ...18 10 Appendix Appendix 1 Color Index...