Asset ATLANTIS 120, Инструкция по установке, эксплуатации и обслуживанию

Страница: 64 / 72

8-6
ATLANTIS - Installation, Use and Maintenance - Man cod.-02 - Rev. 02/2011
use a new piece of blotting-paper slightly dampened
with not aggressive detergent and disinfectant products
diluted in water.
Do not touch the dispensing points with dirty hands.
Do not use solvents or alcohol-based products. The
ventilation slits of the dispenser, on the right side, must
be cleaned by using a dry brush.
8.6 Water dispenser sanitization
Every 6 ÷ 12 months of use of the dispenser, it will be
necessary to follow a sanitization cycle to prevent possible
bacteria contaminations.
This operation must be carried out by skilled technical
staff or by technical service center or by the authorized
reseller only.
In case of a long inactive period in which the dispenser
is not used, it is compulsory to carry out a sanitization
cycle; sanitize the dispenser after each filter replacement
or after a period in which the dispenser is not used for
one or more weeks. Every week of use, as stated in the
previous table, sanitize the dispensing nozzle.
Unscrew the nozzle and dip it in a sanitizing liquid for
food use, for about 10-15 min. Then, rinse the dispensing
nozzle copiously, with water and screw it again in its seat.
8.6.1 Dispenser sanitization procedure
(with Everpure filter)
ATTENTION: This operation must be carried out by
skilled technical staff or by technical service center
or by the authorized reseller only.
By using the appropriate sanitization kit, proceed as
follows:
1. Close the tap that supplies water to the dispenser.
2. Pull the room temperature water lever (central tap)
until the dispenser doesn’t dispense water.
3. Release the water filter to be replaced from the sup-
port, rotating it of one half-turn.
4. Insert a dose (1 glass) of sanitizing liquid (laundry
bleach, for ex. AMUCHINA) in the container of the