Asset ATLANTIS 120, Инструкция по установке, эксплуатации и обслуживанию

Страница: 62 / 72

8-4
ATLANTIS - Installation, Use and Maintenance - Man cod.-02 - Rev. 02/2011
8.3b Filter replacement (Touch Model)
ATTENTION: This operation must be carried out by
skilled technical staff or by technical service center
or by the authorized reseller only.
ATLANTIS Touch Model is controlled by a microprocessor
which, through special sensors, signals any malfunction
and turns off the dispenser when dangerous conditions
arise, such as leaks. Inside the dispenser there is a
special monitoring system that, supported by the chip
card, controls the filter service life and advises the user
when it should be replaced.
In relation to the type of filter, with a standard use of
the dispenser it is compulsory to change the water filter
cartridge at least once a year or every six months.
Once the filter is wet, even if the dispenser is not used,
it has to be replaced within a period of 12 months or
in accordance with the technical specifications of the
filter manufacturer.
Each spare filter is equipped with an electronic smart card
that will be necessary to unblock the dispenser if one
of the previous conditions, that require the filter repla-
cement, occurs.
The dispenser will also be blocked if the smart card is not
inserted or inserted in a wrong way.
At each filter change, it is a good rule to note down the
date of replacement by directly writing it permanently
on the new filter installed.
Proceed as follows:
1. insert the smart card, supplied with the new filter,in
the proper fissure (fig.8.3);
2. close the water interception tap;
3. press the room temperature water key and keep it
pressed until the dispenser doesn’t dispense water;
4. Place a cloth under the cartridge and subsequently
turn the coupling head of the cartridge of one-half
turn and remove it by pulling down;
5. fit again;
6. open the interception tap of water and check the seal,
press the room temperature water dispensing
key and dispense at least 10 litres of water;
7. make available a cloth, position it under the cartrid-
ge and subsequently turn the coupling head of the
fig 8.3