5
An ASSA ABLOY Group brand
80-8420-0900 Rev. B (05-08)
II
-B How to change hands (Interchangeable Core Cylinder & Non Cylinder Locks)
II
-A How to change hands (Standard Cylinder Locks)
Step 1 Remove the Handle
A. Insert the key into the lock.
B. Rotate the key 70 degrees clockwise
C. Depress retainer with tool provided
D. Slide the lever off the lock.
Step 2 Remove Lower Escutcheon Assembly
A. Remove (2) slotted flat head screws.
B. Remove lower escutcheon assembly.
C. Remove cover from assembly by sliding it off the assembly.
D. Rotate cover 180° and reinstall cover on the assembly.
E. Set aside until Step 4.
Lower Escutcheon Assembly
Cover
Step 3 Rotate the lockbody.
A. Remove the small pan head screws.
B. Rotate the lockbody 180 degrees.
C. Reinstall the lockbody and screws.
Step 4 Reassemble
A. With the lockbody rotated (see Step 3) and the lower
escutcheon assy rotated (see Step 2) install the lower
escutcheon using the (2) slotted screws.
B. Install the handle by rotating it to the proper handing. Slide it
on the shank.
C. Install the key and rotate back to the 70 degree position (see
Step 1). Continue to slide the handle until it seats completely
on the shank.
D. Rotate the key and remove the key. Insure the handle is
properly installed by pulling on the handle. If the handle
comes off repeat C & D.
Figure1
Figure2
Figure 3
Step 1 Remove Lower Escutcheon Assembly
(See step 2 above)
Step 2 Remove the Handle Assembly
A. Remove the retaining ring and carefully remove
the handle assembly by pulling it straight out of the rose
assembly.
B. Pull the escutcheon cover off and rotate it 180 degrees
and reinstall it.
C. Rotate the handle assy 180 degrees and reinstall it
by replacing the retaining ring.
Remove Retaining
Ring & Handle
1
Rotate Handle & Retaining
Ring 180°
Replace Handle & Retaining Ring
in this Position
.
3
2
Step 3 Rotate the Lockbody
(See step 3 above)
Step 4 Reassemble
(See step 4 above)
