3
An ASSA ABLOY Group brand
80-8420-0900 Rev. B (05-08)
IMPORTANT:
The accuracy of the door preparation is critical for the proper functioning and security of this
lever handle trim. Misalignment can cause premature wear and tear and a lessening of security. Also if the
door has been previously prepped for another trim it may be necessary to use a Retro-Fit Mounting Plate to
hide the excessive prep in the door. See page 2.
SECTION
PREPARE THE DOOR
I
What does the door look like?
Wood Door
Blank
Refer to Section A (Below)
I
Wood or
H.M. Door
Refer to Section B (pg. 4)
I
2. Drill door.
a. Start with the door face and drill the 2-1/8" (54mm)
hole ½ way thru the door.
b. Drill the remainder of the holes again ½ way thru the door.
c. Repeat steps a & b on the back face of the door.
I
-A Prepare the Door.
Blank Wood Door
1. Mark door and position template.
a.
b.
c.
Refer to the Device instructions to properly draw the
horizontal and vertical center lines for the lock on to
the door face. This will ensure the proper backset and
correct height from the finished floor.
Align the door template with the vertical and horizontal
center lines. Mark the location of all the holes.
Repeat steps a & b on the back face of the door
Caution:
Be sure to use the door stop and not the door edge for
the vertical centerline.
Note:
To avoid splintering wood doors, drill
holes from both sides.
Tools Required
*2-1/8" (54mm) hole saw
*1" (26mm) boring bit
*7/16" (8mm) drill bit
*#2 Phillips screw driver
*Slotted screw driver
*3/8" or ½" power drill
INSTALLATION
TEMPLATE
C
L
C
L
HORIZONTAL
CENTERLINE
VERTICAL CENTERLINE
TAPE TO DOOR
