13
Installation Instructions
SE LP10 9600 Series Exit Device
With MELR
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
7) Installation Instructions (Continued)
*For non-fire rated interior doors, no fire shield or gasket is required.
1. For fire-rated doors only
, install reader backplate and fire shield to
door using two (2) #8-18 x 5/8” Phillips flat head self-drilling screws
(Fig. 3a).
2. For exterior doors, install reader backplate and gasket using two (2)
#8-18 x 5/8” Phillips flat head self-drilling screws (Fig. 3b).
3. For non-fire rated interior doors, no fire shield or gasket is required;
simply install backplate using two (2) #8-18 x 5/8” Phillips flat head
self-drilling screws.
3. Install
Reader Backplate and (Optional*) Fire Shield or Gasket
Fig. 3b
Gasket
(for exterior doors)
Reader
Backplate
Fire plate
Outside Face
of Door
(2) #8 x 5/8” Phillips flat head
self-drilling screws
Fig. 3a
4. Install SE LP10 Reader and Trim Bezel:
Observe precautions for handling electrostatic sensitive devices.
!
If the SE LP10 reader is installed with a module (Fig. 4a), make
sure that the reader is powered down when inserting/removing
the module; i.e., do not “hot-plug” (remove/insert while reader is
powered) module as it may damage the reader.
Fig. 4a
