C o o p e r W i r i n g D e v i c e s
P a g e |
9
Installation
Mounting the RFTCP
The RFTCP can be set on a shelf and may be mounted horizontally or vertically. While the
unit can be located just about anywhere, these simple installation tips should be observed:
Allow for adequate airflow around the unit.
If possible, install an uninterruptible power supply or surge suppressor to protect the
unit from power outages or line voltages fluctuations.
Locate near other home automation equipment for easier connectivity.
Port Layout
A description of each port is included below.
Figure 1: Rear Panel of RFTCP
1.
USB 2.0
–
Allows the RFTCP to monitor and control the Aspire RF USB interface
in
addition to other USB
interfaces
.
2 ports are provided. Use one port with the Aspire
RF Z-Wave USB interface (provided).
2.
Audio Out –
Connect this jack to any audio system for broadcast of text-to-speech
alerts, announcements and reminders. May also be used with Windows Media Player
or iTunes for broadcast of music (software plug-ins are required).
3.
Microphone
In –
Connect a microphone to this port for voice control of the RFTCP.
4.
Power Switch
–
Turns the unit on or off.
5.
VGA Monitor
–
To configure the unit directly, plug a VGA monitor into this port.
Alternately, the unit may be configured remotely from another computer on the LAN or
