C o o p e r W i r i n g D e v i c e s
P a g e |
21
Creating an Event
Naming the Event
The
Event Properties
screen is where basic options for the specified event can be set, such as
the name of the event, whether or not it will respond to voice commands, and so on. To get
to the screen, click Add Event from the
Events
screen to create a new event, or click the
Name tab from the
Event Trigger
and
Event Actions
screens.
Give the event a name, such as “Porch Lights On”. To be able to run the event by voice,
specify the voice command that will be used to trigger the event and select whether the voice
command can be given via microphone, telephone, or both. To have the RFTCP confirm the
command before running the event, enable the
Confirm Voice
field. Type a four-digit number
in the
DTMF Trigger
field to be able to run the event by pressing the corresponding buttons on
telephone keypad. Select any other options you would like to enable for this event by
checking the appropriate check box in the
Options
field.
Specifying the Event’s Trigger
The
Event Trigger
screen lists all trigger and condition types available in the RFTCP. To get to
this screen, click the Trigger tab from the
Event Properties
or
Event Actions
screens.
In this screen, select the type of trigger that will run the event, such as a specific point in
time, an email message is received, a device changes status, etc. Select which days of the
week the event can run, whether the trigger has additional conditions that must be met, and
Figure 8: Events Page
