Appendix
Optional 19” Rackmount Kit for Two ENCHORUS Devices (RM ENC DUAL)
ENC 1202
Version 1.0 Page
45
3.
Remove the rubber bumper from the ENCHORUS’s front panel.
4.
Using two cylinder-head screws, attach the long front blind (3) to the right edge of
the ENC 1202’s front panel.
5.
Using two cylinder-head screws, attach the short front blind (4) to the left edge of
the ENC 1202’s front panel.
6.
Loosen the four cylinder-head screws at the back of the ENC 1202 and remove
them.
7.
Remove the rubber bumper from the ENC 1202’s rear panel.
Take care to hold the ENC 1202’s rear panel in place.
8. Retighten the two cylinder-head screws on the right side of the ENC 1202’s rear
panel.
9.
Using two countersunk-head screws, attach the diagonal reinforcement brace to
the left side of the ENC 1202’s rear panel.
10.
Using two supplied countersunk-head screws, attach the reinforcement brace (2) to
the right rear side of the long front blind (3).
11.
Connect the RJ45 patch cable (1) as shown in the illustration.
12.
Install the assembly in the desired 19” rack.
5.2 Optional 19” Rackmount Kit for Two ENCHORUS Devices (RM ENC
DUAL)
There is also an optional 19” rackmount kit for 2 ENCHORUS devices (1U).
Preparing the First Device (the left one in the rack)
1.
Loosen the four cylinder-head screws at the front of the first ENCHORUS and
remove them.
2.
Remove the rubber bumper from the ENCHORUS’s front panel.
