Ashley AGVF340, Инструкция по установке и эксплуатации

Страница: 6 / 36

6
WARNING: FAILURE TO POSITION PARTS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE
TO USE ONLY PARTS SPECIFICALLY APPROVED WITH THIS HEATER MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
WARNING: POSITIONING OF LOGS IS VERY CRITICAL (SEE DIAGRAM ABOVE)
(1) Rear Log, (2) Middle Log, (3) Left Top Middle Log, (4) Right Top Middle Log (5), Left Front Log (6), Right
Front Log (7), Glowing Embers in front of 5 & 6 logs. IMPORTANT: Place log five on the left and log six on the
right. If they are not properly installed they will be loose and may cause damage to the appliance.
WARNING: POSITIONING OF LOGS IS VERY CRITICAL (See Figure Above).
1. Place rear log #1 on rear log supports. The log has alignment notches on each rear corner.
2. Place Middle log #2 in front of rear burner tube and then move log forward. The log should seat just
behind brass knob (s), located in middle section of base between rear burner tube and front burner pan.
3. Place Left Top Middle log #3 on pins located on left top section of Middle log #2.
4. Place Right Top Middle log #4 on pin located on right top section of Middle log #2 and align notch on
right side #4 with side shield on right.
5. Place Left Front log #5 on locator pins located on left middle section of front burner pan.
6. Place Right Front log #6 on locator pins located on right middle section of front burner pan.
7. Provided with your log set is a package of Glowing Embers (rock wool). Open package and tear off
small pieces of wool material and place it over small holes (ports) located on front burner pan in front
of logs #5 and #6. Cover entire section of holes (ports).
*Replacement of loose (Glowing Embers) must be purchased from the original manufacturer and application
of excess loose material may adversely affect performance of heater.
NOTE: “Wash your hands immediately after coming in contact with wool material. The wool can cause slight
itching or burning in some cases, avoid any contact with eyes.”
“WARNING: All previously applied loose material must be removed prior to replacement.”
1
2
3
4
5
6
7
E.S.B. LOG SET PLACEMENT FOR MODEL 384
“MILLIVOLT ONLY”
LOG SET PLACEMENT