Ashley AGVF340, Инструкция по установке и эксплуатации

Страница: 18 / 36

18
FINISHING YOUR FIREPLACE (ZC)
There is a wide variety of finishing material available for your fireplace from formal wall treatments with marble
and mantels, to rustic wood paneling, stone or brick. Noncombustible materials used in this installation such
as slate, tile, marble, etc. must be at least 1/2" thick.
IT IS IMPORTANT THAT BLACK FACE OF FIREPLACE NOT BE COVERED WITH ANY TYPE OF COMBUSTIBLE MATERIAL.
Check to see whether man-made brick and stone are made of non-combustible materials before using them
on face of fireplace. Some of these products contain combustible materials. Combustible wall coverings
such as paneling or wall-board may not overlap black face of fireplace. Space between wall covering and
fireplace should be sealed with a heat resistant material such as rock wool insulation or mortar.
NOTE: An “L” shaped steel lintel must be installed across top of firebox opening where facing materials such
as brick or stone is used on the face of firebox. It acts as a support/firestop. It should be attached to face of
fireplace with screws and sealed to fireplace with a heat-resistant sealer.
CLEARANCES (ZC)
To ensure a safe installation, following figures dimensions must be carefully observed.
20” MIN. CLEARANCE TO
MANTEL OR SUPPORTS
7” MIN.
CLEARANCE
TO SIDE WALL
SIDE WALL
24” MIN.
CLEARANCE
TO CEILING