Ashley AGVF340, Инструкция по установке и эксплуатации

Страница: 25 / 36

25
SECTION XI
AFTER MARKET MOBILE HOME INSTALLATION
NOTE: See “Producing Adequate Air For Combustion And Ventilation”
THIS APPLIANCE MAY BE INSTALLED IN AN AFTERMARKET*, PERMANENTLY LOCATED, MANUFACTURED (MOBILE)
HOME, WHERE NOT PROHIBITED BY LOCAL CODES.
*After Market: Completion of sale, not for purpose of resale from manufacturer.
THIS APPLIANCE IS ONLY FOR USE WITH TYPE OF GAS INDICATED ON RATING PLATE. THIS APPLIANCE IS NOT
CONVERTIBLE FOR USE WITH OTHER GASES.
NOTE: For mobile home installation follow “Installation” sections in this manual.
NOTE: See “Producing Adequate Air for Combustion And Ventilation”
Although your gas logs are very realistic in appearance, it is not a real burning fireplace and must not be
used for burning rejected material.
• To avoid irreparable damage to heater or personal injury, matches, paper, garbage or any other material
must not be placed or thrown on top of logs or into flames.
• To avoid personal injury, do not touch hot surfaces when heater is operating.
• Close supervision is necessary when heater is being operated near children.
CLEANING
WARNING: THE LOGS ARE MANUFACTURED FROM BONDED CERAMIC FIBER. THIS IS A
COMMONLY USED MATERIAL IN INDUSTRY WORLDWIDE. IN EVENT THAT A LOG SHOULD BE
REMOVED, CARE SHOULD BE TAKEN NOT TO DAMAGE BONDED MATERIAL. INTENTIONAL
MISUSE OR DELIBERATELY FRAGMENTING MATERIAL COULD LEAD TO INHALING FIBERS AND
BE HAZARDOUS TO YOUR HEALTH.
THIS HEATER IS INTENDED FOR USE AS A GAS HEATER FIREPLACE AS DESCRIBED IN THESE
INSTRUCTIONS. IT SHOULD IT SHOULD NOT BE USED FOR ANY OTHER PURPOSE.
CAUTION: BEFORE CLEANING OR MOVING THESE LOGS OR OTHER PARTS OF HEATER, BE SURE
TO READ ABOVE SECTIONS ON “IMPORTANT SAFEGUARDS.”
• Appliance must be turned “OFF” before cleaning inside firebox (burn area), make sure pilot is “OFF”
completely and appliance has cooled.
• All cleaning should be carried out when heater is cold. Limited cleaning is required with normal use.
Dusting front of base, top of piezo cover or control knob panel may be required occasionally. Do not
use cleaning fluids to clean logs or any other part of heater.
• If flames show unusual shapes or behavior or if burner fails to ignite properly, burner holes may require
cleaning. If this occurs, contact your nearest dealer to service heater.
• The heater can be cleaned by removing logs. Lift logs gently, as not to damage fiber pieces. The logs
have been spot glued in place for shipping, use caution when removing. Lift each log by holding it
carefully at each end. Use a vacuum cleaner to remove dust and loose particles from base, logs and
around burner and ODS/Pilot. Gloves are recommended to prevent fibers from breaking skin. If skin is
broken, clean with soap and water.
WARNING: FAILURE TO KEEP THE PRIMARY AIR OPENINGS (S) OF THE BURNER (S) CLEAN MAY
RESULT IN SOOTING AND PROPERTY DAMAGE.