11
Attach the brake band.
Thread it through the
screw eye and then tie the
springs as illustrated.
Put the brake band over
the grooved end of the
bobbin.
Do not over stretch the
springs.
Tie the threading hook to
the front maid upright
with tape.
Attach the flyer unit to the
side rails with 2 screws and
washers, do not tighten
yet.
Move the flyer unit until
the wheel and large flyer
pulley are aligned. Then
tighten the screws.
Check the end of the
adjusting knob is not
protruding beneath the
maiden bar. Then place
the drive belt around the
wheel and large flyer
pulley. Tie the drive belt
and cut off the extra.
Содержание TRADITIONAL SPINNING WHEEL
Страница 2: ...2...
Страница 3: ...3 x1 x1 x2 x2 x1 x1 x1 x1 x1 x1 x3 x13 x2 x4 x4 x1 x2 x2 Real Scale Hardware List 3...
Страница 4: ...4...
Страница 17: ...17...
