Ashford TRADITIONAL SPINNING WHEEL, Инструкция по эксплуатации

Страница: 12 / 18

12
Attach the flyer unit to the
side rails with 2 screws and
washers, do not tighten
yet.
Move the flyer unit until
the wheel and large flyer
pulley are aligned. Then
tighten the screws.
Check the end of the
adjusting knob is not
protruding beneath the
maiden bar. Then place
the drive belt around the
wheel and large flyer
pulley. Tie the drive belt
and cut off the extra.
Single drive ratios:
The ratio with the drive
belt around the large flyer
pulley is approx.
7:1. To spin a finer yarn
while treadling at the
same speed, move the
drive belt to one of the
cneter pulleys - either 9:1
or 12:1.
To spin a very fine yarn,
move the drive belt onto
the small flyer pulley and
retension it. This ratio is
approx. 17:1.
Refer to the Learn To Spin Booklet for more spinning hints.
Happy spinning.
How to insert the polyurethane conrod joints into the conrod.
*This has been pre-assembled in the factory.