Aseptico AEU-27A, Инструкция по эксплуатации и техническому обслуживанию, Страница: 8 / 36

6
After the unit has been set up, you are ready
for quick start operation as follows:
1. Turn the Power Switch on the rear panel of
the console from the 'OFF' (O) to the
'ON' ( ) position. The Console Display will
turn on. An introduction will scroll across the
screen then briefly display the software
version installed:
AEU-27A Endodontic Motor
Ver. X.X
Ver. Date (Mo/Day/Yr)
The AEU-27A is programmed at the factory
to initially start up with File Series S1 active.
Subsequently, when the power is turned on,
the last used settings will be active.
2 . Insert an endodontic rotary file into the
handpiece.
3. Press and release the Ratio
button once to display the
currently selected handpiece/
ratio, then continue to press and
release the RATIO button to cycle through
and select the other available handpiece/
ratio options. (The default ratio setting is 8:1
reduction.)
4 . Use the Calibration function to
calibrate the handpiece for the
AEU-27A. Before calibrating,
ensure that the correct handpiece
ratio is selected. Press and release the CAL
button.
The following prompt will display:
The unit will run for approximately 30
seconds, measuring the handpiece for an
accurate display of speed and torque
values.
CAUTION - Before calibration, ensure that
a file or bit is secured in the handpiece.
NOTE: Pressing, holding, then releasing
the CAL button will enable the system’s
advanced setup options menu. Refer to the
Advanced Operation section for complete
instructions.
If calibration is successful, the following
prompt will appear then the unit will return
to the last settings used:
If calibration fails, the following prompt will
appear advising the user to press the CAL
button to escape out of the test and then
check the motor/handpiece for problems:
l
QUICK START OPERATION
Testing In Progress...
Please Wait.
Calibration Successful!
Please Wait.
Calibration Failed!
Check Motor and Retest.
Press “CAL” to Escape.