Asentria SiteBoss 571 UserManual
Page 13
Internal I/O contacts
4 pair of contact points plus a power output, configured from right to left as follows:
4 pair of dry contact points. These appear as the internal 4-CC inputs on the
menu.
1 pair of contacts for 12VDC power output.
Front Panel LEDs
Each RJ45 port on the front panel has two LEDs associated with it
– one on the Right of the port, one on the Left
of the port.
Console Port
● Right – Lights solid green when a correctly configured cable from a PC/laptop is connected to the Port.
Otherwise this LED remains off. As the Console Port receives data, this LED will flash red.
● Left – Lights solid green when power is applied to the S571, regardless of whether a cable is
connected to the Console port or not. As the Console Port transmits data, this LED will flash red.
I/O Port 1 thru I/O Port 12 (and any additional 4-I/O Port cards that may be installed)
● Right – Lights solid green when a correctly configured cable from another device is connected to it.
Otherwise this LED remains off. As the I/O Port receives data, this LED will flash red.
● Left – Lights solid green when power is applied to the S571, regardless of whether a cable is
connected to the I/O Port or not. As the I/O Port transmits data, this LED will flash red.
Ethernet Ports (Ethernet 1 and Ethernet 2)
● Right – Flashes yellow/green when network traffic (Ethernet packets) is being transmitted or received
across the port. When no traffic is actually being transmitted/received, this LED is off.
● Left – Lights solid yellow/green when an Ethernet cable is connected to the port and an active Ethernet
network. The LED is off when the cable is disconnected from the network, or the Ethernet Port.
Front Panel Buttons
The only button on the S571 is the Reset button. It is on the front panel to the right of the 4 dry contact points.
The Reset button can be used for three different functions:
1) To reset the S571
– press the Reset button for approximately 1 second and the left serial I/O port LEDs on
the front panel will flash once. Release the button. 90 seconds later the unit will beep twice indicating it
has rebooted.
2) To add or remove Expansion Cards
– press the Reset button for approximately 5 seconds and the left
serial I/O port LEDs on the front panel will turn off. Add or remove Expansion Cards. Press the Reset
button for approximately 5 seconds and the left serial I/O port LEDs on the front panel will turn on. 90
seconds later the unit will beep twice indicating it has rebooted. Refer to the
chapter later in this manual for more information on installing or removing Expansion Cards.
3) To activate the
feature which resets the username and password back to the default. This
feature can be disabled via the command interface at Security Settings / General Security Settings. This
feature is intended to be used if you've locked yourself out of the unit.
