User manual for ASIN Aqua
10
Step 3
Connecting the disinfection agent
and pH agent Dosage Tubes
Connect the pH injection valve to the pool water pipe UPSTREAM from
the chlorine injection valve . This reduces limescale build up .
1.
Cut your clear plastic tube at 90 degree angle to ensure proper fitting .
y
Use a sharp knife or razor to cut the tubes cleanly .
2.
Make a 6 mm hole in the lid of your chlorine container and push through
enough clear plastic tube to reach the bottom of the container .
y
Extra tube in your container will bend and allow air bubbles into the system .
3.
Attach the tube weigh to the end of your clear plastic tube .
4.
Connect your clear plastic tube from the chlorine to the left
side of the chlorine pump of your ASIN Aqua .
5.
Connect your clear plastic tube from the right side of your
chlorine pump to your chlorine injection valve .
y
Thread = G 1/4” .
6.
Ensure your valves are not blocked or damaged and
connect to the water supply of the pool
7.
Repeat the steps for your pH dosage connection using the pump on the right side .
WARNING:
Only hand tighten the connections . Do not use pliers or wrench .
ASIN Aqua uses a regulated amount of the chemical agents for disinfection
and pH regulation ensuring optimal efficiency and consumption .
WARNING:
Do NOT connect the pH to the chlorine pump, or the chlorine to
the pH pump . In case of a crossed connection, after ten doses your ASIN Aqua
displays an ERROR warning . Press the red ERROR button to list the faults . Correct
the tube installation and then resume operation of your ASIN Aqua .
CHLORINE
pH-
Drill a hole
in the lid
for the tube
Ø 1 mm
Ø 6 mm
