TD 92232GB
2005-06-15 / Ver.G
Installation Guide
ELISE2
8
Authentication
There are two different users in all ELISE2 products; admin and sysadmin.
The user
admin
has the default password "changeme" and is used for administration and
simple troubleshooting of the product. The admin has permission to change all passwords
except the sysadmin password.
The user
sysadmin
has the default password "setmeup" and is used for advanced
troubleshooting. The user also has access to all administration pages. The sysadmin has
permission to change passwords for all users in the product.
In addition, there are two other users in some ELISE2 products. One is called
user
and the
default password is "password". This user is product dependent and what it is used for is
described in corresponding product documentation. This user does not have access to the
administration pages where passwords normally are changed. The user can change its
own password on the following page;
http://xxx.xxx.xxx.xxx/admin/public/user_chpass.shtml. The password can also be changed
by the users admin and sysadmin.
The other user is called
ftpuser
and the default password is "changemetoo". The user is
available in products with a FTP area. The user can change its own password on the
following page; http://xxx.xxx.xxx.xxx/admin/public/ftpuser_chpass.shtml.
Administration
To access the web pages below, the user
admin
is used.
The web page "xxx.xxx.xxx.xxx/admin" is used in most occasions, for example:
• System setup, i.e. System 900 configuration
• Troubleshooting information
• Changing passwords
On the following occasions, the web page "xxx.xxx.xxx.xxx/system" must be used.
• Current software installation has to be replaced.
• No software is installed on ELISE2.
• Compact Flash image update or installation
The system page can also be used when configuring network parameters.
4
Installation
ELISE2 should be placed in a dry environment with a temperature range of 0 to +40°C.
The ELISE2 module can be connected via system bus cabling, or via twisted-pairs together
with other units in the System 900. The ELISE2 modules can communicate with each other
via the TCP/IP network.
IMPORTANT:
The ELISE2 module must be mounted in a vertical position to ensure
sufficient cooling for the electrical components.
IMPORTANT:
Always follow the instructions in
3.2 Power Down and Restart of ELISE2
when disconnecting the power to the ELISE2 module.