28
| Installation
Aruba 9004-LTE Gateway
| Installation Guide
This section provides the detailed instructions for mounting the LTE antenna to a wall using the wall
mounting brackets provided in the kit.
The LTE antenna mounting instructions are recommended for indoor use only.
Required Tools and Equipment
The following tools and equipment are required for installing an LTE antenna:
Mounting bracket for wall mount installation.
Use 3/4 inch long #6 pan head wood screws for mounting 9004-LTE unit on wood (not included in
the kit).
Use 3/4 inch long #6 pan head wood screws with plastic screw anchor #6-8 x 1 inch on dry wall or
concrete wall (not included in the kit).
Required quantity: 2 screws per bracket
Suitable screwdrivers (not included in the kit)
Installation Steps - Horizontal
To install an LTE antenna to the wall using a 20 feet or a 40 feet cable, perform the following steps:
1. Remove the protection caps from the LTE antenna connector. See
Figure 29
.
Figure 29
Removing the Antenna Connectors
2. Use the appropriate extension cable (Aruba 90xx-LTE Antenna Extender Kit-20ft or Aruba 90xx-
LTE Antenna Extender Kit-40ft antenna kit) to connect the LTE antenna with the device. See
Figure
30
.
Ensure that the Main and Diversity antennas are placed at least 15 cm apart, in case of extended antenna
placements. The greater the distance between the two antennas, the better will be their RF performances.
For best results, place the GPS antenna close to a window or any place with open access to the sky.
