Aruba 9004-LTE Gateway
| Installation Guide
9004-LTE Gateway |
11
DC Power Connector
The AC-DC adapter kit with the following specification is used to power the Aruba 9004-LTE
gateway:
12V/2.5A power interface
Center-positive 2.1/5.5 mm circular plug, 9.5 mm length
Reset Switch
The Aruba 9004-LTE gateway includes a recessed button for resetting the gateway configurations.
Insert a pin into the Reset Switch hole until you feel the pin touch a surface. Push and hold the pin
for two seconds to reset the gateway configuration.
Ethernet Ports
The Aruba 9004-LTE gateway is equipped with four 10/100/1000BASE-T Gigabit Ethernet ports (0
to 3). Gigabit Ethernet uses all eight wires and each pair is bidirectional, which means, the same
pair is used for both data transmission and reception.
Figure 5
illustrates the Gigabit Ethernet
port pin-out for an RJ-45 connector. The pins paired on a 10/100/1000Base-T Gigabit Ethernet
port are: 1/2, 3/6, 4/5, and 7/8.
Cellular
Link Status
NOTE:
The link
status is applicable
to cellular uplink
and is independent
of the hardware,
that is, either the
internal LTE
module or the
external LTE
dongle.
Green (Solid)
Modem Initialized and Connected to
the Network. Good Signal Strength.
Signal Strength Threshold:
> -65 dBm
Green (Blinking)
Modem Initializing
Green + Amber (Greenish
Yellow) (Solid)
Modem Initialized and Connected to
the Network. Average Signal Strength.
Signal Strength Threshold:
< -65 dBm
> -80 dBm
Amber (Solid)
Modem Initialized and Connected to
the Network. Poor Signal Strength.
Signal Strength Threshold:
< -80 dBm
Amber (Blinking)
Network Connection Failure. SIM
Removal. Modem not Responding to
Web Commands.
Red (Solid)
Modem Lost IP Address or
Disconnected from the Network.
Acting as a Backup Uplink.
Red (Blinking)
Hardware Failure. USB Failure.
Unsupported USB Device Attached.
Table 6
LED Status
LED
Function
Indicator
Status
