12
| 9004-LTE Gateway
Aruba 9004-LTE Gateway
| Installation Guide
Figure 5
Figure 3 Gigabit Ethernet Port Pin-Out
Ethernet Port LEDs
Each 10/100/1000BASE-T Ethernet port is equipped with two LEDs that allow basic monitoring of
link/act and status activities.
LINK/ACT
: Placed on the left side of the port, and displays the link status and activity of the
port.
STATUS
: Placed on the right side of the port, and displays the status of the port based on the
CLI.
The following table describes the LED behavior for each mode:
Micro-USB Console Port
The Aruba 9004-LTE gateway is equipped with a Micro-USB (type B) connector that provides
direct local console access. If both Micro-USB and RJ-45 console ports are connected, the Micro-
USB connection takes precedence over the RJ-45 console connection.
Micro-USB Driver
To use the Micro-USB console port, you must install the Aruba Micro-USB driver on the computer
that will manage your gateway. To download the driver, perform the following steps:
1. Go to
https://support.arubanetworks.com
.
2. Click on the
Tools & Resources
tab.
3. Open the
USB Console Driver
folder.
4. Open the
Mobility Gateway and Mobility Access Switch
folder.
Select the appropriate file for your application. The corresponding operating system is in the file
name.
Table 7
10/100/1000BASE-T Ethernet Port LEDs
LED
Function
Mode
Indicator
Status
LINK/ACT
Link status
NA
Green (Solid)
Link established
Green (Blinking)
Port is transmitting or receiving
data
Off
No link
STATUS
Port status
Speed
Green (Solid)
Link at 1000 Mbps
Off
Link at 10/100 Mbps
1000Base-T Gigabit
Ethernet Port
RJ-45 Female
Pin-Out
Signal Name
1
2
3
4
5
6
7
8
BI_DC+
BI_DC-
BI_DD+
BI_DD-
BI_DA+
BI_DA-
BI_DB+
BI_DB-
Function
Bi-directional pair +C
Bi-directional pair -C
Bi-directional pair +D
Bi-directional pair -D
Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B
Bi-directional pair -B
