Artos CS-327, Руководство пользователя

Страница: 16 / 133

16
8. To open the feed belts press the “ Feed Rollers ” button.
The feed belt tension is set via the regulator on the front panel.
40 to 60 PSI is a nominal pressure to start with. The
general rule is to use the min pressure need to do the job.
Excessive pressure or insufficient pressure will accelerate
belt wear.
The EMERGENCY STOP button must be released, the guard closed and MASTER
START pressed before the Feed Roller button will function To release the
Emergency Stop button rotate the button clockwise until the button pops up.
9. Insert the wire though the guides and position the leading end of the wire at the
left end of the infeed belts about 2” on to the belt. Jog the feed about 3 inches
twice then jog it to the end of the feed tube. Do not feed it into the outfeed guide. The
CS 327
will
feed a predetermined length of wire and cut it off to qualify the end of the wire for first piece
accuracy. This piece must be free to drop in the scrap tray .This will happen each time the Feed
belts are opened and closed or the Emergency Stop button is used.
Close the feed belts by pressing the “ Maste r Start and Feed Rollers ” buttons.
10. Select the “ Single ” mode (#7) and press the “ Cycle Start ” Button. This will produce one sample
piece. Examine the part, make necessary adjustments, and repeat as necessary. When results are
satisfactory select “
Auto ” mode press “ Cycle Start ” to commence production.
Pieces made In Single or Step are not counted as part of the total quantity
WIRE AND STRIP LENGTH SETTINGS
Wire (#1) and strip (#2) length are entered by double clicking on the appropriate window; the field
will turn blue, enter the desired values and press
ENTER .
STRIP STROKE (FULL OR PARTIAL)
Strip Stroke (#3) length is entered by double clicking on the appropriate window. The field will turn
blue, enter the desired values and press
ENTER . If the value is the same as or longer than the strip
length the slug will be pulled of completely. If the value is less than the strip length value the slug will
C D
E
A&B
SPARE BLADES
LOWER MACHINE DRAWER