Artos CS-327, Руководство пользователя, Страница: 49 / 133

49
o
Hot stamp with FB+75 – is a heat transfer type marker. Examples are HS4140. The
difference between this and the Hot Stamp is that the machine waits for 75mS after
receiving the ready signal, before it starts pulling wire. This is for markers that are
basically using the stamping cylinder power as the ready signal.
o
Wraptor – Brady Wraptor for doing wire wrap labels. This process will trip the
Wraptor to put the label on. The user must select the label to be printed on the
Wraptor before running the CS327 does not transmit the label data.
o
Slitter is for axial slitting of the wire
o
Steady on / other turns on the preprocess and looks for a ready feedback. This would
be for use with a Clinton HF-15A Spark tester or an ultraviolet curing light.
o
Continuous II – is a heat transfer type marker. Examples are WM6, KIP 20. This
process is the same as the Hot Stamp except that it is a special mode of printing that
hot stamp does not have. This is just for continuous printing and you can program a
distance from the end of the wire to the first mark and you can program the distance
between the marks.
Post Process Configuration
Post-Process configures the installed post process devises.
Besides the values defined below there are two other parameters in the General tab that can have an
effect on the how the post process operates

Clear part distance is the distance the outfeed drive will travel when discharging a finished
part. This occurs at the end of the programmed quantity or on every part when Auto outfeed is
selected. Making this distance longer will cause the post-process device to operate for a
longer time. For example on a CD-17 coiler, making this distance longer will cause the bowl
to turn for a longer time thus pulling the end of the wire out of the tube and into the coil.