Art Hobby Momentum 1500mm SAL DLG F3K, Руководство пользователя

Страница: 9 / 17

9
5.Cut small opening between posts projecting from top aileron
surface (close to the back post) and remove all material until you
see bottom veneer inside opening. Photo 44
Note: The opening need to be small enough to be completely
covered by horn back plate after is installed.
3. Take horns back plate and place on aileron surface centering
on the pencil line with front of the plate being flush with front edge
of the aileron. Now using pencil make mark on veneer center of
each plate hole.
4. Drill holes in marked position then insert control horn posts into
holes and using ruler check alignment. Photo 43
P. 44
9. Using soldering iron (set to low heat) melt projecting post flat
with the plate surface. Photo 47
6. Mix small portion of 5 min. epoxy and using toothpick fill
opening with epoxy.
7. Secure horn with back plate pushed over the posts. Wipe out
any epoxy that may have gotten squeezed out from under back
plate. Photo 45
8.
After control horns and their back plates are secured the nylon
posts should be trimmed so they project out 1mm above back
plate. Photo 46
P. 42
P. 43
P. 46
P. 45
10.Using small flat fine file or fine sanding paper wrapped around
spreader stick sand melted surface smooth. Photo 48
P. 47
P. 48
Momentum-DL v.1