Art Hobby Momentum 1500mm SAL DLG F3K, Руководство пользователя

Страница: 14 / 17

14
20. Hold boom with elevator tube pointing UP then positioning
stabilizer mount on the top with front of the mount aligned with
masking tape edge then us pencil and outline its position.
Photo 77
21. Put mount temporarily aside and clean the marked surface of
the boom with sand paper. Then position mount on the boom and
glue it in place with a few droplets of thin CA adhesive ( #A0106) .
Fine applicator tips (#A0303) are recommended for this operation
tip will help applying CA very precisely. Photo 78
19. Using soldering iron (set to low heat) melt projecting post flat
with the plate surface and sand melted surface smooth.
Photo 76
P. 76
22. Now take the vertical stabilizer and using hobby knife with
sharp blade cut slot in marked position to accept the boom.
Photo 79
After cutting check stabilizer fitment on the boom (should fit
snug). If satisfied remove it and put aside for a moment.
23. Mount horizontal stabilizer then place vertical stabilizer
back on the boom, centering on the boom aligning it
perpendicular to the horizontal stabilizer. Photo 80
25. From supplied fiberglass cloth cut two rectangular pieces
25mm x 45mm, they will be used to secure permanently vertical
stabilizer to the boom. Photo 82
24. Holding in position secure vertical stabilizer to the boom
with a few droplets of thin CA adhesive. Photo 81
P. 79
P. 80
P. 81
P. 82
P. 77
P. 78
Momentum-DL v.1