Art Hobby Momentum 1500mm SAL DLG F3K, Руководство пользователя

Страница: 10 / 17

14. Next mount servo arm on the servo shafts and secure with
screw. Photo 50
16. To improve aerodynamics and esthetic look of the glider we
recommend covering aileron servos with Art Hobby’s universal
wing servo covers (#A0031). Photo 52
11. Place the servos in the center of servo bays, lock the ailerons
in a neutral position securing both ends of each control surface to
the wing’s trailing edge with a piece of tape.
12. Now measure distances between servos control arms and
aileron control horns, according to these measurements make
two short push-rods from the supplied wires.
We suggest making “Z” bend on both ends. Photo 49
13. First connect push-rod to the aileron horn, then to the servo
arm. Photo 49
15. Now position servo in it’s bay immobilizing it in place with
balsa shims made from balsa board and pushed between servo
and front and back wall of the servo bay securing all with small
amount of silicone sealer. Photo 51
P. 49
P. 52
P. 50
P. 51
Wing Mounting
1. Place the wing on the fuselage wing saddle, then use a sharp
pointed pencil to mark the wing’s trailing edge on the fuselage.
2. Remove the wing, then measure the distance between the
marked line and the center of the two threaded holes in the wing
saddle.
3. Place the wing upside down and transfer both measured
distances onto the bottom center of the wing joint, they should
match previously made markings.
4. Using 4mm drill bit and drill from bottom side two holes in the
marked position.
Remember that the hole has to be drilled at an angle to match
the angle of the wing bolt screwed into the fuselage.
5. Find two M4 wing screws and screw them into the wing saddle
to check the angle, then from the top side of the wing open the
holes properly to fit the wing screws.
Push-rod Installation
Best method to install push-rod tubes inside tail boom is
attaching them to wedge shape push-rod installation balsa
board (
included in the kit) board will fit inside the boom’s entire
length. After inserting board with tubes into boom friction
will hold it in place.
Balsa board is too long to fit inside glider box so was specially cut
in two pieces and packed together with glider wing in the box.
1.Use thin CA adhesive glue both board pieces together. Photo 53
2. Place push-rod tubes on the board spaced ~2mm apart
at the back end of the board with one tube projecting ~60mm from
back of the board and other tube projecting ~140 and tack them
with few drops of CA. Photo 54
Gradually spread tubes apart moving forward to wider end of
the board gluing them to the board with CA adhesive.
As final step use sewing thread and wrap board with tubes
securing them together and making few extra windings on both
ends of the board. PHOTO 54 & 55
P. 53
Momentum-DL v.1 10