Art Hobby Momentum 1500mm SAL DLG F3K, Руководство пользователя

Страница: 7 / 17

Wing Servo Installation and Wiring
We recommend HS-45HB Hitec servos to be used for the ailerons
1. Connect each of the aileron servos to the receiver.
2. Turn ON the radio and center servos, use the servo reversing
in the transmitter if the servo moves in the wrong direction.
3. In preparation to install aileron servos first remove control
horns from both servos and cut off mounting tabs. Photo 29
4. Cut off plug connectors from servo wires.
5. In bottom of wing center joint cut small rectangular opening to
accommodate 4-pin connector. Photo 30
P. 29
6. Run servo wire through the wing panel (Push-rod tube can be
used to help pull the wire through). Photo 30 & 31
11. Holding connector face down solder both servo wires to the
connector. Be very careful to keep the polarity correct. Photo 35
P. 30
P. 31
7. Position servo properly in their bays and pull both servo wires
from the center opening to eliminate any slack. Photo 32
8. Cut both wires approximately15mm from the wing and using
masking tape mask wing around center opening Photo 33
9. Lift up servo in their bays and pull servo wires from center
opening will be easier soldering wires to the plug with extra wire
slack. Photo 34
P. 32
P. 33
P. 34
10. Take the 4-pin female connector and cut short soldering pins.
With shorter pins it will be easier gluing it into the wing. Photo 34
P. 35
Momentum-DL v.1
7